Hi
Wanting this shield to go in a sculpture and to always be one when the arduino is on. So if i have a power cut or someone un plugs then when it gets plugged backend it will automatically start up again. Two options that I thought of
1) solder the switch to be on all the time.
2) solder the switch so that I can controlled it from the arduino board.
Of course 1) is easier but I don't really understand if this a good thing or not. Don't want to blow things up or have it not start. Anyone done this or have advice around how to do this?
cheers Paul
Statistics : Posted by paul27 • on Sat Dec 28, 2013 4:53 am • Replies 0 • Views 1
Wanting this shield to go in a sculpture and to always be one when the arduino is on. So if i have a power cut or someone un plugs then when it gets plugged backend it will automatically start up again. Two options that I thought of
1) solder the switch to be on all the time.
2) solder the switch so that I can controlled it from the arduino board.
Of course 1) is easier but I don't really understand if this a good thing or not. Don't want to blow things up or have it not start. Anyone done this or have advice around how to do this?
cheers Paul
Statistics : Posted by paul27 • on Sat Dec 28, 2013 4:53 am • Replies 0 • Views 1