Pads between boards are too small

Hi,

I've tried to order a few (my first) prototypes yesterday, and received a very quick response telling me my gerber files don't meet the requirements.
However, I don't understand what the problem is. I was told:
"The comments for your PCB file are:
the PAD between boards are too small. please make them at least 6mil width.".

I haven't made any panel or so on the gerber files, so I really don't understand what it could be... Could it be my keep-out line that i made very thin (i think that should be the only thing smaller than 6 mil in my design) ? I don't see why that should matter since it's only used to tell where to cut the pcb, and I also wouldn't expect that to be called a pad . Or have I missed some point here?

Anyway, if someone has been having the same problem, I'd appreciate if he could tell me what to change.

Thanks!

Statistics : Posted by pbobbink • on Thu Dec 05, 2013 8:39 pm • Replies 1 • Views 41

---