Hi,
I had exactly the same problem. My netduino device was running for 2 days when it suddenly stopped sending data to my web service via the GPRS V2 shield. It seemed like the network indicator light that flashes green stopped. I could however not restart the shield pressing the reset button on the side. Here are my questions, perhaps someone can help:
1.) Generally when I restart the GPRS shield by pressing the button on the side nothing happens. I keep it in for longer than 2 seconds yet nothing. Should I see something visually when I reset?
2.) In order to get the software restart working via PIN 9 and after I soldered the JP pads together on the board, I can write the code to set it to low and high but yet nothing happens
3.) The only way I could getting the unit to respond again was to pull the power from my netduino and put it back again where after both started working again.
Any ideas??
Riaan
Statistics : Posted by israel.g.88 • on Fri May 15, 2015 4:14 pm • Replies 4 • Views 176
I had exactly the same problem. My netduino device was running for 2 days when it suddenly stopped sending data to my web service via the GPRS V2 shield. It seemed like the network indicator light that flashes green stopped. I could however not restart the shield pressing the reset button on the side. Here are my questions, perhaps someone can help:
1.) Generally when I restart the GPRS shield by pressing the button on the side nothing happens. I keep it in for longer than 2 seconds yet nothing. Should I see something visually when I reset?
2.) In order to get the software restart working via PIN 9 and after I soldered the JP pads together on the board, I can write the code to set it to low and high but yet nothing happens
3.) The only way I could getting the unit to respond again was to pull the power from my netduino and put it back again where after both started working again.
Any ideas??
Riaan
Statistics : Posted by israel.g.88 • on Fri May 15, 2015 4:14 pm • Replies 4 • Views 176