Grove Button

Hi,

I can't get the Grove Button to work with the Linkit One.

I've configured the pin as a input and tried with many different pins.

The digitalRead command always returns a 1 and if I've pull the pin to ground I get a 0.

When measuring the voltage over the pin and I get 2.25 V.

I think the pins are always pulled high through a internal pull-up and that you need to pull the pin low instead of high as the Grove button is designed?

Or is there a way to control the pull-up resistor of a pin?

Kind regards,
Frederik

Statistics : Posted by freddotnet • on Wed Mar 18, 2015 3:23 am • Replies 1 • Views 15

---