Serial not working

Hey guys,

I was trying to run the Wifi example provided in secton 5.3 of the official Developer's Guide.

However, I can see nothing from the Serial Monitor in the Arduino application, nor any errors show up.

The Arduino version I use is 1.5.8, I tried this on a 64-bit Windows 7 as well as a 32-bit Windows XP, both resulted in the same behaviour. So my question is: is there any particular setup I need to make serial working here?

Thanks a lot!

Statistics : Posted by xxuejie • on Fri Dec 12, 2014 10:04 am • Replies 4 • Views 147

---