Wifi shield: hardware factory reset

Hi,

My Arduinoa 2560 Mega + WiFi started displaying periodically the following scan messages:

SCAN:Found 5
Num SSID Ch RSSI Sec MAC AddressSuites
1 mau 06 -67 WEP xxxxxxxxxxxxxxxx xxxx
2 Oak 06 -76 WEP 10:6f:3f:0f:72:07 3104
3 Oak 11 -52 WEP 10:6f:3f:0f:98:4d 3100
4 yo 11 -76 WPAv1 00:0d:0b:36:16:73 TKIPM-TKIP 1104
5 Oak 11 -82 WEP 10:6f:3f:0f:8e:70 3100

I don't succeed to put it properly in command mode using terminal() inside the loop(). I do receive the CMD answer after issuing a $$$ command, but this is all ---- immediately the above scan messages start being displayed.

Is it possible to do a hardware factory reset like in the RN-XV WiFly Module, where you have access to the GPIO-9 pin ? Where in the WiFi shield is it available ?

Statistics : Posted by rubensmau • on Wed Apr 17, 2013 4:50 pm • Replies 2 • Views 24

---