Hi,
I bought a Grove 3-Axis Digital Accelerometer (http://www.seeedstudio.com/depot/grove- ... Path=25_26) and a Grove 3-Axis Digital Gyro (http://www.seeedstudio.com/depot/Grove- ... p-750.html, though behind it says v1.2b) and I can't make them to work together. If one is connected to the I2C then it's working fine, I can read the data but if both are connected impossible to get anything, the entire sketch doesn't work, I can't even run any sketch, I need to disconnect and reboot the board. My setup is pretty conventional : Galileo Gen1, Grove Shield.
My understanding by http://www.seeedstudio.com/wiki/I2C_And ... ed_Product is that their address are different so I'm wondering what's wrong with what I do. Note that If I connect say the RGB LCD and say the Gyroscope or the Accelerometer it works (all 3 also doesn't work).
Any idea?
Statistics : Posted by alexis-menard • on Sat Sep 27, 2014 4:28 am • Replies 0 • Views 27
I bought a Grove 3-Axis Digital Accelerometer (http://www.seeedstudio.com/depot/grove- ... Path=25_26) and a Grove 3-Axis Digital Gyro (http://www.seeedstudio.com/depot/Grove- ... p-750.html, though behind it says v1.2b) and I can't make them to work together. If one is connected to the I2C then it's working fine, I can read the data but if both are connected impossible to get anything, the entire sketch doesn't work, I can't even run any sketch, I need to disconnect and reboot the board. My setup is pretty conventional : Galileo Gen1, Grove Shield.
My understanding by http://www.seeedstudio.com/wiki/I2C_And ... ed_Product is that their address are different so I'm wondering what's wrong with what I do. Note that If I connect say the RGB LCD and say the Gyroscope or the Accelerometer it works (all 3 also doesn't work).
Any idea?
Statistics : Posted by alexis-menard • on Sat Sep 27, 2014 4:28 am • Replies 0 • Views 27